中空玻璃打膠機是現在中空玻璃廠家的常用設備之一了，但是我們在使用中空玻璃打膠機的時候可能會出現很多的情況，其中有一種是中空玻璃打膠機泵連續運轉并報警的情況，一般出現這種情況由哪幾種原因導致的呢？下面雙組分打膠機廠家就給大家分析一下。
Hollow glass gluing machine is one of the common equipment in hollow glass manufacturers, but when we use the hollow glass gluing machine, there may be a lot of situations, one of which is the continuous operation of hollow glass gluing machine pump and alarm. What are the reasons for this situation? The following Shuangzefen glue machine manufacturers will give you an analysis.
原因：膠已用盡。
Reason: The glue has run out.
解決：更換膠桶。
Solution: Replace the rubber drum.
原因：膠桶內有空氣，或壓不到膠。
Reason: There is air in the rubber drum, or it can't press the glue.
解決：打開壓盤上的放氣閥，出膠后關閉再打開膠泵上的放氣閥，出膠后關閉。
Solution: Open the vent valve on the pressure plate, close the vent valve on the rubber pump after tapping, and close the vent valve after tapping.

原因：膠料缸電接點壓力表失靈。
Reason: The pressure gauge of the electric contact point of the rubber cylinder is out of order.
解決：更換新的電接點壓力表。
Solution: Replace the new electrical contact pressure gauge.
原因：膠泵電機反轉。
Reason: Rubber pump motor reversal.
解決：調整膠泵電機相序，重新接線。
Solution: Adjust the phase sequence of rubber pump motor and reconnect.
今天的精彩內容就暫且和大家介紹到這里了，如果大家有其他想要補充的地方，歡迎大家到雙組份打膠機的官網給我們留言評論：http://m.yalais.com，或者直接撥打我們的咨詢熱線，我們將給您一個滿意的答復！
Today's wonderful content will be introduced here for the time being. If you have anything else to add, you are welcome to leave a message and comment on the official website of the two-component glue machine: http://m.yalais.com, or call our hotline directly. We will give you a satisfactory answer!